What we take on
From a single LV rewind to a plant-wide drive retrofit. Every job starts with a written scope and ends with test data.
We work on low voltage motors up to 1 kV and medium voltage machines up to 11 kV, whether they drive pumps, fans, conveyors, compressors or machine tools. The workshop handles strip, rewind, machining, balancing, assembly and test under one roof, so a motor does not travel between three subcontractors before it comes back to you.
On site we install and align motors, commission drives and build or modify control panels. Because the same engineers quote the work and then do it, the scope you sign is the scope that gets executed unless the strip reveals something nobody could see from outside, and in that case you get a call and a revised price before we continue.
Every repair leaves with a test sheet: insulation resistance, winding resistance across phases, surge comparison, no-load current and vibration. That sheet is what your maintenance file needs when the next auditor arrives.
Service lines
Pick the line that matches the problem, or send us the symptoms and we will point you at it.
Repairs and rewinds
LV and MV motors, brakes, pumps and gear units. Strip, rewind, machine, balance and test.
Installation
Base preparation, mounting, coupling alignment, belt tension and commissioning.
Drives and controls
VFD and soft starter retrofit, panel builds, wiring, parameter sets and handover.
Condition monitoring
Vibration surveys, thermography and oil checks with trend reports on a schedule.
Breakdown response
24/7 line, collection inside 120 km, emergency rewinds prioritised in the diary.
Spares and exchange
Bearing and seal kits, exchange motors for the most common frames, kept on the shelf.
Tell us what the motor is doing
Overheating, tripping, noisy bearings or a drive that faults under load. Describe it and we will tell you what to check first.