A workshop built around the motor
Strip, rewind, machine, balance, test and install in one building, run by engineers who answer the phone themselves.
Wolfpower started as a rewind shop serving local pump and conveyor users who could not get a straight answer on lead times. The rule we kept from those days is simple: nothing gets quoted without a written scope, and nothing leaves without a test sheet.
Today the workshop runs two shifts with a third on call for breakdowns. Low voltage machines up to 1 kV are usually turned around inside a day; medium voltage work up to 11 kV is scheduled and supervised by the same engineers who quote it. Installation crews cover a 120 km radius and take the motor from the truck to commissioning.
We keep spare bearings, seals and a small stock of exchange motors for the frames we see most often, so a failed motor does not wait for a purchase order to clear before the line can run again.
Want the workshop tour?
Come and see the rewind bay, the test bench and the panel shop. Bring a nameplate and we will talk through the repair route.